The Ceiling Canopy / Ceiling Rose
We supply our “Stem Canopy” – a 11cm Diameter Die-Casted Ceiling Rose that comes with female loop pre-installed. The ceiling rose is supplied in Black Ace (EBA) Finish, and is designed to take the full weight of the fixture.
We provide a steel Adaptor Bracket with threaded holes located at the left and right of the adaptor bracket. 8-32 x 3/4″ Pan Philips Screws are supplied (roughly M4 x 20mm long) in the same colour as the canopy, ensuring the entire fixture, and fixings appears the same colour on the ceiling.
Yup, everything is then packaged into a brown or white paper bag and marked with your colour, size, installation instructions, and any applicable warnings.
Outdoor Rated Cables
Our Standard Black Cord [SBC] / Standard White Cord [SWC] are designed for outdoor usage.
All other types of cables are designed for internal use only. This may be due to single insulation (French Braided Twist), or Polyester jackets (Black Cloth Cord) that contain non uv-treated cables.
We cut all of our cable off 100m spools. The supplied length of 1m is provided for all cable styles. If you require additional lengths further than 2m long (3.5m TOTAL), we can supply a quotation separately. Cable supplied always has a “little bit of slack” to enable the electrician to complete their installation.
Indoor Rated Canopy
For all of our Chain Hung Pendants, a dry location must be selected for the installation/electrical termination point. This means that water cannot be present in the immediate area at any stage.
We use a outdoor-rated silicon that ensures water cannot enter the electrical assembly (through where the cable enters) through the lighting fixture. It is quite literally “plugged” prior the electrical assembly being completely assembled.
Yes. Your electrical termination must be completed into/using an Outdoor Rated Enclosure (as your electrician to supply) so that water-proofing is completed.
For example; An outdoor alfresco area may have the chain-hung pendant fully exposed to the weather.
The lighting fixture is water-proofed externally, the lighting fixture’s electrical connection point is terminated within either A) Recessed, dry location (i.e. under a roof). or B) within an outdoor-rated conduit box.
The Chain can be “Hooked” wherever desired, with the electrical terminated in either location A or B.
Outdoor Rated Pendants (IP44) and up, can be always placed in full weather conditions so long as the ceiling is “dry”.
All Barn Light Lighting takes a common “E27 / Edison Screw / ES / Screw Bulb” that you’ll find at your local hardware, or grocery store. If you’d prefer to purchase our LED Bulbs, the supplier (VintageLED.com.au) provides a three-year warranty.
Yes – We use a ceramic Edison Screw (E27) Lampholder.
Whats.. Better? Ceramic?!
Our ceramic/porcelain Lampholders are simply designed to take as much heat as possible (Yes, We build better lighting than our competitors) without effecting the mounting / electrical cabling. Our outdoor pendant lighting is based on decades old, reliable, vintage engineering.
Standard Outdoor Barn Lights – 100W
If you select the “default” arrangement which is simply marked as “Edison Screw Lampholder (No Bulbs Supplied)” with Standard Black Cord – You’ll have the ability to install a 100W Bulb.
Atomic Barn Lighting / Indoor Rated Cables – 60W
If you select an Accessory such as “Atomic Cast Guard” or French Braided Twist – When installed with Glass, you’ll be limited as the sealed glass enclosure becomes a literal heat-trap, resulting is a lesser Wattage rating (60W)
You can opt to NOT install the glass at your discretion however Atomic “Fully Integrated LEDs” required the installation of glass at all times.
What you *may* want to know if considering purchasing elsewhere
Our competitors will be supplying you with a thermo-plastic lamp-holder which becomes brittle & cracks over time, with a maximum of 60W being typical (also.. not organic / not recyclable). Need to light up an area? Nope – You’ll now need to install spotlights to find your car in Winter.
Smart Bulbs – When you need a kaleidoscope of colour.
Yes, our lighting is fully compatible however we suggest that you try one bulb in the most furthest away location from your wireless signal. We manufacture with Aluminium, and you’ll likely install your new Barn Lights onto Brick or Concrete walls. Neither of these materials are ideal for wireless signals to penetrate through so tread cautiously.
Yup – We hear you, this is sounding too good to be true for a lighting company.
Frankly (the short answer is “Yes”), we could write a page about this – so we did.. -> Are Barn Lights Dimmable?
Yes – We have been developing our lighting for years and it is ready to integrate with any sensor on the market today. Your electrician, or related professional will work closely with you to determine which solution best suits your needs, but don’t worry: to put it simply, buying a Barn Light is the easy part of your lighting plan.
The types of sensors available on the market today are microwave (movement), lux meters (during dusk-to dawn periods), and PIR Sensors for night (heat sensor). The best solution for you will depend upon your local conditions, thus supplying a motion sensor isn’t under the purview of the lighting products we provide.
For example: If you live in an area with nocturnal life, you wouldn’t want to install a motion sensor in your backyard covering a large amount of area. For similar reasons, you wouldn’t want a heat sensor covering the sunset as stone holds heat for a long period of time. Some video cameras these days now have a “pre-determined scope” or area of control to focus on, ignoring all else such as a driveway, ignoring the surrounds.
If you are wanting to install a light *sometimes* when entertaining, you’ve got a portable, chain hung pendant to solve that problem.
If you are concerned about the fixtures swaying the breeze, our chain hung lights are resistant to light breezes, otherwise we’d recommend our stem pendant lights for windier conditions as a fixed installation.
If you’ve got a ceiling that may have some additional protection required, consider an upgrade to our optional Atomic Cast Guards which increase the IP Rating to IP55 and provide an interesting focal point.
For the Kitchen
A typical 1.8m-2.1m (x 900|1200mm) Island bench should have 2x kitchen island pendants installed equally spaced provide sufficient light during the daytime and evening when using the larger shades, smaller shades 3x. For every 400mm of space, the addition of one extra pendant is preferable. The higher you install your pendants, the greater light dispersal, the less pendants are required. Whilst balance makes sense, its not always easy to visualise online!
Our Chain Pendants would typically be installed over the kitchen island bench rather than over the dining room table.
For the Bathroom
“The smaller, the better” – Sparkie dependant, we insist upon using the cast guard & glass to reduce water exposure and diffuse light more evenly (Atomic Cast Guard drops the bulb to just before the shade rim in most shade models). A unique benefit for these units is the addition of optional Atomic Cast Guards which increase the IP Rating to IP55.
For Workshops – You’ll definitely feel a industrial vibe once installed, and spend more time in the workshop that before!
For Walkways, a shorter pendant drop will provide less momentum for chain hung pendants to swing.
For Garages, a long chain suspended pendant will always look aesthetically pleasing while providing a decent quality light.
Are you in the market for a Barn Light?We will teach you everything you need to know about our range of Outdoor Lights or “Barn Lights” as we call them as well as the benefits of each type.
Mel & Jesse – We’re real people behind our family-owned small business, making Industrial & Modern Lighting for your home and small business. We manufacture our Lighting, something that gives us great joy to work with fellow Aussies.
What makes it a “Barn Light”? An Australian Made & Owned Lighting Manufacturer dedicated to creating the highest quality outdoor rated lighting that Australia has to offer.
We’re in the business of making your home, and business noteworthy. We work alongside both Designers & Tradies to get the job done, the first time around.